3D mockups · Printed sports gear
Nº D-11226
15.75 × 8.1 inch face, 5 inch handle — a wide sweet spot for beginners. UV print or a sublimated face sheet, edge to edge on both sides inside the guard. Sizes are a guide; measure the real blank before production.
Made for: Fashion & retail, Office & business.
Sample UV-printed on the surface.
Sample size 206 × 14 × 400 mm.
A custom pickleball paddle — UV print or a sublimated face sheet edge to edge on both faces, inside the edge guard; club, tournament and gift paddles.
Yes, commercial use included; Free adds a watermark grid at 1K, Pro exports 4K without it.
Yes — from the 206 × 14 × 400 mm sample or your own size.
Yes, on every plan including Free: use them on your website, marketplaces, social media and for clients. Pro removes the watermark and exports 4K pictures.
The sample is paper decal 80 gsm with gloss lamination.
A pickleball paddle has a polymer (PP) honeycomb core about 13–16 mm thick, two carbon-fibre or fibreglass face sheets bonded either side, an edge guard round the rim and a grip wrapped in rubber or PU. The face is the print area: the graphic is printed directly on the face sheet or on a film moulded into it, then a grit layer goes on top. USA Pickleball rules cap paddle length at 17 inches and length plus width at 24 inches, so shapes differ only within that envelope.
Carbon faces (often T300, T700 or raw carbon) feel solid and spin well; fibreglass faces are poppier, cheaper and suit beginners. The real print substrate is composite, not paper; the paper decal on the sample page only simulates the graphic. For short runs of branded gift paddles, makers usually UV-print onto finished blanks rather than moulding new faces.
Direct UV printing gives vivid colour with a white underbase, but the ink can wear after long ball contact; sublimation or film moulded in during pressing lasts longer because the image sits under the surface coat. The grit layer on top darkens and dulls colours slightly. The edge guard has its own colour, so match the artwork to it.
Design on the exact face shape of the blank, keeping an 8–10 mm safe zone inside the rim because the edge guard hides the outermost part; artwork can bleed up to the guard but keep type out of it. Each face is a separate file and front and back can differ; the throat near the handle is narrow and curved, fit only for a small logo. Supply 300 dpi at actual size in the colour mode the maker's UV printer wants.
It is the widest of the three, so the sweet spot is large and off-centre hits twist the paddle less; the short 5 inch handle is light and quick at the net.
Yes, the face of nearly 206 mm allows a wider landscape logo or a larger square image than the other two shapes — good for gift paddles with long company names.
On finished paddles the maker UV-prints straight onto the face, which suits small quantities; for large custom orders the graphic is sublimated or moulded in as a film during pressing, which lasts longer.
Graphics on the face are allowed as long as dimensions and surface roughness stay within the rules; paddles for sanctioned events must also be on the approved paddle list.
Carbon faces are stiff with good control and spin, suiting experienced players; fibreglass is poppier, softer on the arm and usually cheaper, suiting beginners and gift paddles.