Nº D-11790
Milk, juice, tea, honey, liquor — tall cylinder, round shoulder, short neck, aluminum screw cap.
Made for: Tết & gifts, Tea & coffee, Food & specialties, Beverages.
Sample printed on paper decal 80 gsm, gloss lamination; style: plastic jars, glass jars, bottles (labels).
Sample size Ø77 × 165.5 mm.
Glass bottles for wine, beer, sauces, juice and ferments — fine-paper or vinyl labels, or direct print. Glass reads premium, protects flavour and recycles.
Yes, commercial use included; Free adds a watermark grid at 1K, Pro exports 4K without it.
Yes — from the Ø77 × 165.5 mm sample or your own size.
Yes, on every plan including Free: use them on your website, marketplaces, social media and for clients. Pro removes the watermark and exports 4K pictures.
The sample is paper decal 80 gsm with gloss lamination.
A glass bottle is blow-moulded in one piece — body, shoulder, neck and a threaded or cork finish — so the designer's work is the label set: body label, neck label, seal strip and sometimes a shrink capsule over the closure. Body labels are applied by a reel labeller or by hand and must sit on the straight section between shoulder and heel. The closure — aluminium screw cap, cork, wooden stopper, swing top or crystal stopper — decides where the tamper seal goes.
80 gsm coated paper self-adhesive label stock suits dry goods, spirits and gift bottles; fish sauce, oils and juices that go into a fridge or ice bucket need white or clear PP film labels, because paper stains and lifts with oil, salt and condensation. Wine and premium spirits often use textured felt papers or wet-strength label paper. For a ‘no-label look’ on clear glass use clear PP with a white underprint.
Paper labels are normally gloss- or matte-laminated so they survive rubbing in the shipping carton; spirits and gift ranges suit hot foil, blind or registered embossing and raised spot UV. For long runs, direct screen printing on glass or a full-body shrink sleeve is an option, but both need dedicated tooling and are slow to change compared with labels.
Measure the circumference of the straight section (π × diameter); leave a 3–5 mm gap for a partial wrap or add a 5–10 mm overlap for a full wrap, and keep the label at least 5 mm short of the shoulder and heel at each end. Use 2 mm bleed and a 3 mm safe zone, and on round bottles run the barcode vertically (ladder orientation) so a scanner can read it. Sloped shoulders, tapered bodies and teardrop shapes need a curved fan-shaped label, never a plain rectangle.
The round shoulder and short neck make it sturdy and easy to pour and clean; the tall straight body takes a near-full wrap label, and at Ø77 × 165.5 mm it suits milk, juice and tea.
The lined aluminium cap seals well, but the label must cope with heat and steam: use PP film with heat-resistant adhesive and apply it after the bottle has cooled.
Paper labels suit spirits, honey and dry products kept dry; anything oily, salty or chilled needs PP film, which doesn't absorb water or tear when the bottle sweats.
Multiply the diameter of the straight section by 3.14 for the circumference, add 5–10 mm for a full-wrap overlap, and take the straight height minus about 10 mm so the label clears the shoulder and heel.
When the run is large, the design will stay unchanged for a long time and you want a premium look that survives ice water; labels remain better for small runs, many SKUs or information that changes often.